Independent, non-commercial guide. Not affiliated with, sponsored by, or endorsed by Pearl, Rio Perla Properties, L.P., or Pearl Brewing Company. PEARL is a registered trademark of its owner. Official district site: atpearl.com.

Roof Forms on Industrial Buildings: Captioned Figures

Roofs on working buildings were shaped by two needs: shedding rain and letting in daylight, and sometimes letting out heat and steam. This gallery describes six figures drawn as simple cross-sections, the view you would get by slicing the building from front to back. Each caption gives the form, and the text explains why a builder would choose it.

Roofs that shed water

Figure 1. Gable roof on timber or steel trusses. Two slopes meeting at a ridge.

The section shows a triangle of rafters supported by a truss below. Small warehouses and sheds used this form because it was simple and drained in two directions. The triangular wall at each end, the gable, often carries the building's date or name in brick.

Figure 2. Flat roof behind a parapet. A nearly level deck hidden by a raised wall.

The section shows the roof falling gently to one side, where water runs through openings in the parapet (scuppers) to downspouts. From the street the building appears to have no roof at all, which suits a strong cornice line.

Figure 3. Mansard roof. A steep lower slope and an almost flat top.

The steep slope, often clad in slate or pressed metal and pierced by dormers, gives a full usable storey inside the roof. Associated with the Second Empire style, it was chosen for show fronts and towers, as on several brewery buildings of the 1880s and 1890s.

Roofs that bring in light and air

Figure 4. Monitor roof. A raised strip along the ridge with windows in its sides.

In section it looks like a small box sitting on top of a gable. The side windows, a clerestory, light the middle of a wide floor and can be opened to vent heat. Monitors are common on foundries, boiler houses and long shop buildings.

Figure 5. Sawtooth roof. A row of steep glazed faces and gentle solid slopes.

The section looks like the teeth of a saw. In the northern hemisphere the glazed faces usually point north to give even light without direct sun. Sawtooth roofs let single-storey plants cover large areas with daylight everywhere.

Figure 6. Tower cap and cupola. A small roof crowning a hoist or stair tower.

Drawn as a pyramid, dome or miniature mansard with a ventilating lantern on top. In tower breweries the cap marks the highest point of the gravity process, where grain was lifted before descending through the building.

What the roof tells you

Pair this gallery with the window types and the brewhouse elevation diagrams.

Sources